Roller Marks From Vinyl Cutter

A roller and paint brush spinning tool available at hardware and paint stores for about 8 simplifies the cleaning task.

Roller marks from vinyl cutter.

And that s almost the exact same response i got when i asked about my mh871 leaving tread marks 7 months ago. The gold thumb screws are what you would want to adjust it would be best to mark the screws where you can know how many turns you have done so that both screws are turned the same amount. You would have better results adding temperature than lowering it. Your wall may look smooth but the roller marks are telling you that it isn t.

Need help with pinch roller marks mh 871. Your prints may be dry to the touch but not to the pressure. I have never had the marks not go away after the vinyl is installed if you want a less agressive mark look at a higher end machine as the knurles tend to be less deep they will still be there though with all machines unless you get a tractor fed like the gerber. You can tighten the pinch roller screws on the back of the cutter to raise the pinch rollers to apply less pressure.

Scrape excess paint from the roller before you wash it. Roller marks are the result of the rollers hitting ink that has not dried yet. Why you need to adjust the rollers and reset setting on the vinyl cutter. Then rinse the roller cover until the water runs clear.

They could also be actual impressions made by the gripper rollers because the thickness and the softness of the vinyl is too much for a latex printer. The best method to follow is simply to ensure that the pinch. Mh 365 721 871 pinch roller adjustment. As stated if it is just decal material only use the outer ones.

Most vinyl cutters will have specific places where the pinch rollers cannot be placed. Pinch roller positioning if your vinyl shifts drastically to the left or right when feeding the first thing to check is the pinch roller positions. Adjusting the rollers will only cause tracking problems among other things. All vinyl cutters will leave pinch rollers marks when cutting they should go away when you apply the vinyl.

You may be using a cover with a 1 4 inch nap which is intended for use on perfectly smooth surfaces. The griper marks arent always due to plasticizers. If there are marks being left on the material from the pinch rollers. I had the same thing happen with clear cling i was using until i switched brands.

These positions may or may not be clearly marked.